Odds of overclocking a dual setup with 2 slotkets

[Shag]

I have been given a Tyan Tiger 133 dual slot 1 board recently and would like to throw in a couple overclocked celerons. How do slotkets affect overclockability? If I get 2 pretested celerons, should I be able to run them at the same overclocked speed using slotkets?

Any slotket recommendations?

Any info would be appreciated. Thanks.

 

[BA]

I've got 2 C366's on a Tiger 100. They're at stock right now, my real problem is cooling the 2nd processor. It doesn't get a lot of air off the back of the first.

The slockets shouldn't really hurt anything. I'm using MS-6905's.

 

[Shag]

Thanks for the info.

Does your board have a 66mHz fsb setting, or are you running them overclocked? How much did you pay for your slotkets?

 

[BA]

They're on 66FSB. Slockets were ~10 from Onvia back when they had free shipping.

They'll do 550, I just have to have my room be freezing. The JB Weld may not have been that good of an idea, or I may not have done the best job affixing the ole HP Orbs on there. May try some AS epoxy, but then I'll have to crack off the HSFs and resand everything.