I had a WD 100GB 8MB hard disk as my boot drive, it was gettting corrupt sectors so WD sent me a new drive. Now after the reinstall of windows XP Pro, my boot drive (the WD) is E: while my old E: drive (Maxtor) is now C:
Windows is on the E: drive, boot drive is setup as primary master and the Maxtor is primary slave. Anyway to change the drive assignments? the only thing that I can think of is the old WD drive wasn't set as master or slave or cable select, it had the jumper in an unassigned location.
Any hints or tricks would be greatly appreciated
Windows is on the E: drive, boot drive is setup as primary master and the Maxtor is primary slave. Anyway to change the drive assignments? the only thing that I can think of is the old WD drive wasn't set as master or slave or cable select, it had the jumper in an unassigned location.
Any hints or tricks would be greatly appreciated
Facebook
Twitter