OC'd barton 2500+'s Post your HS+fan specs and temps

[Slash621]

Just list the overclock.... heatsink........fan (if adjustable the rpm speed).. many thanks!

 

[Slash621]

bumpz

 

[Slash621]

bump again

 

[VisableAssassin]

ive got two 2500+'s so ill listem from oldest to newest.
first production run 2500+ (about 7 months old now) 2.3ghz 1.975v on an alpha pal8045 with a sunnon 50cfm fan stayed at around 110f idle and about 125-130f load......ive since switched to water so that chip was sitting at 90f idle 100f load on a maze3 1/2in fitted
and yes its still running at 1.975v

and my newest barton is a week30 2500+ @ 2.3ghz 1.9v sits at a nice 86f idle 95-100f load depending on my room temp and the damn humidity here. this is on a D-tek TC-4 rev2 which has taken the place of my maze3

 

[Iron Woode]

I have mine very slightly overclocked. I use a 11.5 multiplier. I use a vantec aeroflow fan and my temps are 31C at idle and 40C under full load. I also use an Antec 835 II case.

 

[Slash621]

anyone else? also temps in celcius if possible

 

[boyRacer]

2500+ @ 3200+ 1.75v week 11

SK7 with TMD fan... idling at 50... load is around ~60... don't know if my board is reading too high but it seems most abit boards are.

 

[Corporate Thug]

2500+@ 3200+ 1.73 actual week 26

slk800 w/ SFII @ 3100 rpm. 41C idle 45C full load

 

[Slash621]

thanks shady06. you posted in another thread of mine and i asked u for these stats.. good to finally see them

anyone else?

 

[beatle]

I'm still settling on a voltage, but I think I'm stuck @ 2178 (11x198). Alpha 8045 w/Sunon ultra high speed fan @ 6v. Temps hover around 44-54 depending on room temp and load.

 

[yruffostsif]

11 x 200 was effortless at stock voltages (43-53 C). Highest stable 11 x 218 at stock voltage (48-59 C).