Newly installed Chaintech 4200 on a Intel 2.5ghz machine and horrible performance!

[Heifetz]

I just replaced my Radeon 8500LE with a new Chaintech 4200. I overclocked it to 283/533 using powerstrip, and ran 3dmark2k1 and got a score of 8096!!!! This is rediculously low! Even my Radeon 8500 was faster! And its so much lower than the average score for 4200TI. Please help me figure out what is causing the horrible performance!

You can view the tests here.
http://service.madonion.com/servlet/Index?pageid=/orb/projectdetails&projectType=6&projectId=4501133


Heifetz

 

[Mem]

Look in Nvidia display properties panel and see if you`ve FSAA on,if so turn it off.

 

[Maggotry]

I don't know if this matters, but did you uninstall of the old ATI drivers and remove the card from the device manager before installing the new gf4 card?

 

[Jeff7]

That may not be too bad at all. I'm on an Athlon XP 1900 with a Ti4200 doing 300/365 and I get around 6000 3dmarks. Of course, I run 3dmark using some decent quality settings. I have anisotropic to level 4, Mipmap LOD to -1.0 (I think those are the settings) and I have User Mipmaps disabled(this lets the application set the mipmap level; it usually chooses low quality settings to enhance performance.)
That said, if I change the settings to lowest quality, I exceed 10,000.