new intel computer up and running

[xxsk8er101xx]

As soon as i can i'll get seti up and going.

New system is
Intel Pentium 4 2.0Aghz @ 2.4ghz
Abit IT7
512MB of PC2700

 

[whitelight]

sounds good. congrats on your assim xxsk8er101xx!

 

[xxsk8er101xx]

thanks ... i hope this computer last much longer then a year! ya know?

 

[micron]

Congrats! 😎

 

[Smoke]

thanks ... i hope this computer last much longer then a year! ya know?

Isn't that the truth. One year and you feel ancient. 😛 😉

 

[xxsk8er101xx]

Lol ya really!

 

[JWMiddleton]

Congrats on the new system! Let us know how it does with SETI!!

 

[Hellburner]

Sure you can't get a few more MHz out of that 2.0A? 😉

My newest is an IT-7 also, I just neglected to notice that it was "legacy free". So, a couple days after I ordered it I was reading the manual I downloaded and discovered I needed a USB mouse and keyboard, then noticed the AGP slot was 1.5 volt only so I needed a GF4 Ti4200 😉 , fortunately my printer had a USB connector...

with pc3200 and a 1.6A I ran it up to 2.8 GHz with the stock HSF, it ran the Ars benchmark wu in 2:48:10. Then I backed it down to 2.66 for stability during gaming.

The onboard sound was problematic in some games and DivX decoding until I went in and turned down the hardware acceleration for the sound card a couple notches.

 

[xxsk8er101xx]

well i got it to post at 2.66 it's just not stable. What are you BIOS settings? So far it's running good at 2.54ghz.

 

[Assimilator1]

Awesome new rig & WU time HB 😀

I see you'll be climbing up the production charts a little😉

xxsk8er101xx
Another awesome rig! ,nice assimilation 😀

 

[Swanny]

Originally posted by: Smokeball

thanks ... i hope this computer last much longer then a year! ya know?

Isn't that the truth. One year and you feel ancient. 😛 😉

Smokeball: You must feel really ancient then😛 😉


xxsk8er101xx: Congrats on the new machine. I hope it lasts you a while!

 

[Hellburner]

I'm running a DRAM Ratio of 1:1 and CAS Latency 2.5

At these outrageous FSB speeds the memory definitely becomes an issue, I just noticed I can reduce the memory speed below the FSB too 😀, I think I'll go back and check that stability in games at 2.8, maybe it was a memory issue...

 

[xxsk8er101xx]

nope i tried that and it didn't work. SO i put it back to 127FSB and 3:4 memory timings. P4 loves bandwidth to so i don't think there would be a difference between the above and 2.66ghz at 133mhz (266) memory timings. at 170 (340) it's getting a decent amount of bandwidth. Gives you 2720MB/s bandwidth. Only 500 less than RDRAM. In benchmarks though it's only 200 points less than pc800 acording to sisoft 2002 SP1 though.

*shrugs* ... too my video card is bad! The memory chips run SUPER HOT on the card itself and it's not even overclocked.