I got my setup completed, and went with the setup that everyone said too on here
Setup is
q9300
Asus P5N-E SLI
8GB DDR2 800mhz
corsair 650w ps
WD 640AAKS X 2
Antec 900
Computer seems to run good, but I can't get this raid setup. I enabed it in the bios, picked the drives that would be Raid in the bios. Then I boot up and it says press f10 to setup raid. If I do that, it wants a System Startup floppy disk.
If i hit control J, it goes to J micron and has a list of driver pages. I can pick either jmicron driver page, or nvidia driver page. I tried both, pick vista 64 and it wants a floppy. I havent tried the floppy yet but not sure why i'd need a floppy. I have the drivers for windows on a usb drive. Where do I go from this page? Where do I set the raid 0 striping and striping size and all that. I tried installing windows without going through all that and it doesnt see the drives, I guess because I didnt get them setup.
Setup is
q9300
Asus P5N-E SLI
8GB DDR2 800mhz
corsair 650w ps
WD 640AAKS X 2
Antec 900
Computer seems to run good, but I can't get this raid setup. I enabed it in the bios, picked the drives that would be Raid in the bios. Then I boot up and it says press f10 to setup raid. If I do that, it wants a System Startup floppy disk.
If i hit control J, it goes to J micron and has a list of driver pages. I can pick either jmicron driver page, or nvidia driver page. I tried both, pick vista 64 and it wants a floppy. I havent tried the floppy yet but not sure why i'd need a floppy. I have the drivers for windows on a usb drive. Where do I go from this page? Where do I set the raid 0 striping and striping size and all that. I tried installing windows without going through all that and it doesnt see the drives, I guess because I didnt get them setup.
Facebook
Twitter