Hello,
I did search for this but found nothing...
If I set my voltage above 1.6v for my P4 3.0E the board fails to boot and goes into the CPR "overclocking failed" press f1 mode. This happens even if I leave Manual settings at default of 200MHz FSB, etc. One increment above 1.6 for the CPU and it fails???
Anyone hit this? Does anyone know of a way around this - BIOS setting, perhaps?
Thanks!
PS.
Have Antec 550 True PSU
Have flashed to several BIOS versions
Have cleared CMOS
I did search for this but found nothing...
If I set my voltage above 1.6v for my P4 3.0E the board fails to boot and goes into the CPR "overclocking failed" press f1 mode. This happens even if I leave Manual settings at default of 200MHz FSB, etc. One increment above 1.6 for the CPU and it fails???
Anyone hit this? Does anyone know of a way around this - BIOS setting, perhaps?
Thanks!
PS.
Have Antec 550 True PSU
Have flashed to several BIOS versions
Have cleared CMOS
Facebook
Twitter