Network Cable termination to keystone and RJ45

[kamaran]

I'm trying to install an outdoor IP CAMERA.

I'm trying to run a cat6 from a wall panel keystone on one (X) side and an RJ45 (Y) connector on the other end to the IP camera.

All connected correctly via the 568-B Wiring wiring method, however when I test with a LAN cable tester nothing is working??

Into the testing tool I'm connecting the RJ45 end (Y) and another cable connected to the keystone (X) which should effectively create a working cable?

Any ideas?!

 

[Ertaz]

Do any of the pairs come through on the cable test?

 

[kamaran]

the separate cable I am using to connect to the keystone jack does fine.

 

[Ertaz]

Is it a punch style keystone jack or a punch less?

 

[kamaran]

Is it a punch style keystone jack or a punch less?

punch style

 

[Ertaz]

punch style

Did you punch it down with a 110 tool?

 

[Ertaz]

Can you post an up-close picture I the crimp on the rj45 end?

 

[kamaran]

problem solved - I had wired the RJ45 crimped side left to right instead of right to left.

Thanks everyone.

 

[imagoon]

problem solved - I had wired the RJ45 crimped side left to right instead of right to left.

Thanks everyone.

You should be matching the color code...