Need help with my MSI MS-6119 mobo

[Byte]

Hi, i'm trying to upgrade this mobo to a PIII 600E. I went to their site and flashed my mobo and looked at the jumpers and all but it still won't boot with a PIII 600E (i have two of them). It is suppose to support up to 800MHz too. Celerons and PIIs with a 66MHz FSB work fine, but the instructions or instructions on the web don't say how i would change it to 100MHz FSB, it says that it is just suppose to be able to detect it accordingly. HELP! Thanks!

 

[Wolfman35]

Very few of the 6119 boards had the right Winbond chip to support Cu-Mine PIII's. A Celeron II on a slotket will work just fine at 100 FSB but a true Cu-Mine PIII just won't post because it locks itself into reset. The ONLY 6119 that supports a PIII Cu-Mine is the one that has the Cu-Mine sticker on the Winbond chip. I bet yours doesn't and I've never seen one that did. They WILL run a PIII Katami CPU and a FC-PGA Celeron on a slotket but not a Cu-Mine. Also note that there are 2 BIOS Types for the 6119. Plug and Play CPU and Standard. The Standard gives you an Advanced option that allows you to set the FSB in some revisions. I believe it is the MS revision but I don't remember for sure.

 

[Byte]

damn there are like billions of revisions.