Hi folks!
I haven't been in here much at all, just got one server crunching Seti WUs. Just read about SB, and thought I'd switch 2 CPUs over to SB, but I need a little help.
I'm running W2K Adv Srver on a 4-way PPro 200 server. I have Seti setup running as four seperate services, each one tied to a single CPU.
I d/l the SB 1.0.0 SMP client, fired it up, and it connected OK, and is running, but gets no CPU cycles because of the Seti clients. How do I:
1. Configure the SB client to use the CPUs I want it to?
2. Run SB as a service, since I don't usually log on to the server?
TIA,
I haven't been in here much at all, just got one server crunching Seti WUs. Just read about SB, and thought I'd switch 2 CPUs over to SB, but I need a little help.
I'm running W2K Adv Srver on a 4-way PPro 200 server. I have Seti setup running as four seperate services, each one tied to a single CPU.
I d/l the SB 1.0.0 SMP client, fired it up, and it connected OK, and is running, but gets no CPU cycles because of the Seti clients. How do I:
1. Configure the SB client to use the CPUs I want it to?
2. Run SB as a service, since I don't usually log on to the server?
TIA,