Need help w/FSB divisors...

[ST4RCUTTER]

Hey peeps,

I'm messin' around with my Shuttle again...going for that top speed and all. My FSB is currently at 145Mhz, but my PCI is still showing 48Mhz. That sounds crazy high, and I'm worried about data corruption to my HDD's. At what point will the 1/4 divisor kick in? I'm thinking 150+ but I'm not sure. I could just try it out, but I'd rather know before I change it. Otherwise I'll prolly be resetting the CMOS. :disgust:

 

[Maniac9127]

It should "kick in" at 133. Are you sure there isn't some jumper somewhere that you've not set right? I don't own an ak31, but on my motherboard there's a jumper for 100 and 133.

 

[ST4RCUTTER]

Doh! The answer was right in front of me and I didn't see it. What I need is the 1/5 divisor which isn't supported yet. Well, ask a stupid question...deserve to be listed as stupid.

 

[ST4RCUTTER]

Ok...back to the tweak workbench. The system seems stable, but 3DMark2001 crashes at the low-detail lobby scene. I've raised my DDR voltage to 2.6. Should I try to raise this higher or try raising the I/O voltage? It may just be that the PNY GF3 ti200 can't handle the 72Mhz AGP bus. Maybe I should throttle it down to 140 and tweak the AGP card only...any ideas?