Need Help Overclocking 1Ghz Tbird

[voogru]

Hello,
I finally decided to overclock my CPU

I took off the Heatsink and Closed the L1 Briges and i put the Heatsink back on.

I turned Jumper Mode ON in my Mobo (ASUS A7V)
now theres sumthing wrong

I can only boot with the Multiplier at 10.5 (1050Mhz) I tri 11.0-11.5-12.0 none work

now i know its probally sumthing i did wrong BUT i was able to change the multiplier to 10.5 with no problems.

what am i doing wrong?

thx!

-voogru

 

[NicColt]

what's your voltage, you have to up your vcore as you up the x

 

[voogru]

How do I set the Voltage???

Ill look in the manual

what would be the voltages for

11.0x
11.5x
12.0x
12.5x

thx!

 

[voogru]

Bump...

 

[SuperKen!]

I dont know how to set the voltage on yoru MB, but there is no exact voltage you need for a certain clockspeed. Just setting the voltage higher will increase your stability in the case of overclocking.

Basically, just set the voltage as high as it can go, and see what the highest speed you can OC it to.
But go slowly, about 50-100Mhz increments.

 

[PlunX]

You'll probably just want to connect the L7 bridges.. That'll make the voltage default at 1.85v, the max that most Socket A motherboards use. If you still can't get it to run faster after connecting the L7 bridges, it just might not want to run any faster..