• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

need help connectng reset/HD/speaker LEDs on my DFI mobo

A

astnfan

Member
Hi there,

I have the DFI lan party UT nF4 ultra D mobo and I a going through the manual and it specifies what the configuration of the front panel connectors on this page:

http://www.dfi.com.tw/Upload/Manual/lputnf4%20847505101.pdf
(pages 63-64)

My case has these connectors, but the manual does not specify what colors go where.

On my case the wires are as follows

HD LED: 2 pin orange and white wires
reset sw: 2 pin both wires are grey
power sw: 2 pin blue and white wires

there is another 2 pin connector with green and white wires only labeles + and -, the + is green and the - is white : i have no idea what that is for

I am clueless on how to place these cables, is white the ground?

Can anyone help, I would be most greatful.
 
Usually the colored wire indicates the + side, but as these wires will not damage anything that is plugged in wrong, plug them in and see if it works, if not just turn the wire around
 
You must log in or register to reply here.

TRENDING THREADS

Back
Top