My Latest Case Mod: Baybus With A Twist.

[Dan]

I just added a Baybus from pcmods to my Enlight 7237. Switch #1 controls the intake fan blowhole and Switch #2 controls the exhaust fan blowhole. Switch #3 controls two red flourescent lights I placed below the vents on the side of the case. Switch #4 controls a blue flourescent light I placed below the vent in the front bezel. I even replaced the #4 red/green LED with a blue LED. (Radio Shack part #2760311, of course.)

I have the flourescent lights held in place with electrician's tape for right now because I want to try them in different spots to see where I get the best effect. (I'm also going to add a second blue flourescent light to the front of the case.)

 

[techfuzz]

Sounds like a nice case mod!

bump

 

[Dan]

Thanks!

 

[SammyBoy]

dan u gotta post sum pics of that!, if you have a camera of course.

can u see the blue shining through the vents in the front of the case at nite, that must look wicked

 

[SammyBoy]

dan u gotta post sum pics of that!, if you have a camera of course.

can u see the blue shining through the vents in the front of the case at nite, that must look wicked

 

[SammyBoy]

hey dan where did you get your lights???


anyone know of places to get colored flourescent/neon lights for less that the 35 bucks that pcmods is charging?????


thanks,

Sam

 

[Dan]

SammyBoy: I got the lights at Autozone. They're very inexpensive.

 

[sparkle]

Sounds cool dan! My homemade baybus uses the following config.
12v/off/7v

sw1- frnt blow-hole
sw2- top blow-hole
sw3- rear blow-hole
sw4- HDD cooler
sw5- neons

12v uses blue LEDs
7v uses red LEDs

Talk to ya later!