My 8KHA+ supports 4X AGP, but my Ti200 is only set to 2X and I can't change it. HELP!?

[simms]

I have an 8KHA+ which I've been using for the past couple months with no problem. I used to have a ASUS V7700 GeForce2 GTS Deluxe which ran at 4X AGP. When I purchased a new Visiontek GeForce3 Ti200 and popped it into my system, it worked. However, I can't change the AGP speed of my new card, which is running at 2X. I tried going into my BIOS and seeing if I could change it, but no luck. Does anyone have any idea what's wrong?

Simon

 

[DevilsAdvocate]

Try the new 4 in 1's from Via.

 

[Mem]

I`ve the same board,anyway make sure you install the VIA drivers in "turbo mode" also check that you`ve the AGP aperture size set at 64mb or 128mb in BIOS.

 

[simms]

Well, I went here: http://www.viaarena.com/?PageID=2
and I got the drivers, but I'm not sure how to install in "Turbo" mode.

 

[simms]

I have the aperature at 128, so that shouldn't be a problem. Anyone think I should try to reseat the card?

 

[Alex]

it might be a jumper setting on the card. my viper2 is like that...

 

[simms]

quite possibly, but I don't think the 6564 has jumper settings But I'll check.