Mushkin High Pref on Abit KR7A-Raid

[Reap]

Hello!

I got a Abit KR7A moderboard with 2x256mb mushkin high pref memory.
Is it possibal to set the DRAM commad rate to T1?
As it is right now I can boot up without problems etc at 143mhz@cas2 with default voltage and with t1!
But it wont run 3dmark.
When I set the commad rate to t2 it works just fine.
What can try to do to make it work with t1?

Thanks!

Reaperman

 

[Hauk]

Surprised you didn't get a response on this. Command Rate 1T is the most sensitive setting. I was able to get everything tweaked, but had to stay with 2T. It's a shame cause 1T gives a serious memory bandwith boost.

If you're running everything else tweaked, FSB around 140 (or better), CAS2, 2-5-2, 4 Bank Interleave, DRAM Queue Depth 4 Level, you might be safe sticking with 2T...

Killer site with wealth of info on the KR7A:

Paul's Unofficial Abit KG7/KR7A FAQ