• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

msi neo 2 platinum

C

crossphyr

Member
I was just wondering. i was running at 2.55 1:1 with around a 1.4 volt on my cpu and it seemed to be a little shady once in awhile.. so i finally flashed my bios to 1.4 and i can now get it to 1.52 and i was wondering if it should be more stable and if its more than likely the voltage that was causing instability? I am using ocz plat rev 2 a gig of it with ultra x connect 500 watt.. so im sure the only thing i can think of is the voltage to the cpu... so right now i have been running it at 1.52 and its running good... oh well ill keep u updated...
 
POssibility...Since the neo2 undervolts in about every category you need a bit of a boost everywhere...Also the higher you run your ram and subsequently the vdimm will draw against everything...What I mean is a cpu stable with a certain vcore with 133 divider and low speed ram with 2.7 or vdimm may not be enough once you switch to 1:1 and raise the vdimm...I have seen it sometimes require one more notch up from where you had it 100% prime solid. In my case I raised the fsb considerably so I can understand a needed boost....
 
You must log in or register to reply here.

TRENDING THREADS

Back
Top