I have been looking at this device as a possible way to mesh separate locations together, and was wondering what kind of equipment others have used to accomplish this.
The version of the PTP 600 I was looking at was the light, which is capable of 150mbs aggregate or 75up and 75down
The design of the network would form a triangle with a few spokes off each corner.
D--C---B----E
...... \ /
........A------F
Sorry for my limited ASCII art ability the periods are just to hold the formatting.
I was looking at using a Cisco 2821 with a 2 routable port ethernet (HWIC-2FE), but I was told the 2821 isn't capable of handling that amount of bandwidth.
So I?m wondering now if I couldn't just put a layer 3 switch at A, B, and C and just link everything that way, since I know it would handle the bandwidth.
Thoughts and Suggestions greatly appreciated.
The version of the PTP 600 I was looking at was the light, which is capable of 150mbs aggregate or 75up and 75down
The design of the network would form a triangle with a few spokes off each corner.
D--C---B----E
...... \ /
........A------F
Sorry for my limited ASCII art ability the periods are just to hold the formatting.
I was looking at using a Cisco 2821 with a 2 routable port ethernet (HWIC-2FE), but I was told the 2821 isn't capable of handling that amount of bandwidth.
So I?m wondering now if I couldn't just put a layer 3 switch at A, B, and C and just link everything that way, since I know it would handle the bandwidth.
Thoughts and Suggestions greatly appreciated.
