motherboard monitor 5

[vietofmars]

I have a little question about using the software?
I have a ABIT SR7-8X board
I have a question about the setting the senors. I went on the mbm website and my board is supported.
It says my cpu senor is Winbond 2 - P2 diode
I'm confuse do i set senor 1 to winbond 2 - diode
but I also can set it to winbond 2 alone by itself.
When i set to winbond 2 - diode it reads 38C
When i set to winbond 2 alone it reads 98C
I don't know which one is correct or which one do i set it too?
Thanks for the help

 

[Tates]

Sensor 1 (CPU) - Winbond 2 - P2 Diode
Sensor 2 (MB) - Winbond 1

 

[Johneverd]

When i set to winbond 2 - diode it reads 38C
When i set to winbond 2 alone it reads 98C


Look in your BIOS (press DEL while booting) to see what the reading is there, then use the setting that is closest to that. The 38C is a reasonable temperature, as at 98C the system would most likely not boot.