Molex remover/sleeving kit

[Ike0069]

I need to mod my Sonata to get bette air flow. While I'm at it, I was thinking about sleeving my PSU. I would need sleeving material and a molex remover. I can reuse the molex's I remove, correct?
Where is a good place to find this stuff?

 

[Alaska]

I use AMP/Molex PIN EXTRACTION TOOL.

http://www.action-electronics.com/molex.htm#Tool (about 1/3 down the page)

You should be able to get one at a good electronics shop.

Yes, You can reuse the molex's.

 

[SVT Cobra]

frozencpu

they also offers these kits, the may be overpriced ect, but if your new to it it can be a great help over there

 

[Zepper]

jab-tech.com svc.com (SVC just came out with a neat tool for the ATX type connectors).

.bh.

 

[Ike0069]

FrozenCPU is a nice site, but they are a little on the high side. Then they ding you on shipping also.
I've looked around on SVC several times, but just now noticed the "wire management" section. 😱 This is what I needed.

Thanks guys. 🙂

 

[duckdown]

if you're canadian, check out bigfoot computers