Maybe asking too much (F@H)

[bluestrobe]

I currently have a few rigs crunching F@H (graphic 5.03). Is there any software I can run that will post the stats from all system into one computer? I'm always checking on the other systems via VNC but that can make things a little slow and labor intensive just to check stats. I seen a few programs out there than can do it for one machine (I still can't find one that reads my progress on this system) and wondered if there was one that did it over a network with static IP addresses. Like I said, maybe asking too much but I thought I would ask.

 

[Freewolf]

http://fahstats.sourceforge.net/

there was another one called kdfold but it doesn't seem to be around anymore.

 

[ProviaFan]

Originally posted by: Freewolf
http://fahstats.sourceforge.net/

there was another one called kdfold but it doesn't seem to be around anymore.

F@H Logstats is what I use also. All you have to do is set the F@H folder on each of the "remote" computers to be shared (read-only for security), and then point F@H Logstats to each of those systems. Let me know if you encounter any difficulties in setting this up. 🙂

 

[MechEng]

There is also a program called Electron Microscope III, that has some really nice features, but unfortunately also a hideous user interface IMHO...

 

[MDE]

Originally posted by: ProviaFan

Originally posted by: Freewolf
http://fahstats.sourceforge.net/

there was another one called kdfold but it doesn't seem to be around anymore.

F@H Logstats is what I use also. All you have to do is set the F@H folder on each of the "remote" computers to be shared (read-only for security), and then point F@H Logstats to each of those systems. Let me know if you encounter any difficulties in setting this up. 🙂

Works great for me too.

 

[bluestrobe]

So I installed "FAHLogStats-0.72-New" and had one question while trying to set it up. It asks you to direct you to the F@H program thats current running. Would this be winFAH.exe or the FahCore_XX.exe's?

 

[MechEng]

Originally posted by: bluestrobe
So I installed "FAHLogStats-0.72-New" and had one question while trying to set it up. It asks you to direct you to the F@H program thats current running. Would this be winFAH.exe or the FahCore_XX.exe's?

Actually it does not matter...

It will generate the correct path anyhow. You can also write the line manually like this:
"F@H1","X:\F@H1\"

Where "F@H1" is the name you give that client, and "X:\F@H_Console\" is the path to the client. You can also use an UNC-path like this:
"F@H1","\\PC2\D\F@H\"

I hope this helps, otherwise you are welcome to ask again... 🙂