Manual DHCP Bindings on Cisco 2600?

[Draco]

This got locked in the "Highly Technical" forum because I didn't follow directions, sorry mods. Maybe someone can help me here.

I'm having a hell of time getting it working. I've been reading Cisco's docs of course and my stuff seems right, but whenever my test pc gets an address it just gets one from the pool when it should be getting the ip that I've hard coded to it's MAC address. ANyone have any experience with this? Any help would be greatly appreciate. Thanks

Here's part of my current config by the way...

ip dhcp database <snip>
ip dhcp excluded-address 192.168.2.1 192.168.2.100
ip dhcp excluded-address 192.168.0.1 192.168.0.100
!
ip dhcp pool 1
dns-server 192.168.2.10 192.168.2.11
default-router 192.168.2.1
domain-name foo.com
!
ip dhcp pool Manuals
host 192.168.2.150 255.255.255.0
hardware-address 0100.104b.75cb.26
ip address 192.168.2.1 255.255.255.0
duplex auto
speed auto
!
interface Serial0/0
no ip address
shutdown
!
interface BRI0/0
no ip address
shutdown
!
interface FastEthernet0/1
ip address <SNIP>duplex auto
speed auto
!
ip default-gateway <SNIP>
ip classless
ip http server
ip pim bidir-enable

 

[DaiShan]

you might also try the networking forum, they have some pro's over there!

 

[Draco]

Not that anyone cares... but I figured it out

Microsoft clients have to use the command "client-identifier" instead of "hardware-address." Naturally a very simple solution to the problem