Lockups and BSOD's....Please help!!!

[stockjock]

I have this message copied over to operating systems as well...my overclocked system has been running stable for months now and then all of a sudden I've been getting a ton of lockups lately, after the lockups I "reset" or turn off the comp. completely and everytime after the reboot I get one of these BSOD's and heres what it says...

"Fatal exception OE occurred at 0167:BFF7283"
or
"Fatal exception OE occurred at 0147:0000663D"

Any help on what is causing these errors would be much appreciated.

 

[Vegito]

did you try un-ocing the cpu and run the machine as is to see if there's more BSOD ?

 

[stockjock]

YUP...same problem...thought someone would know what the codes meant..

 

[stockjock]

bumpity bump

 

[han888]

hmmmm try to reinstall the os

 

[mrchan]

how high is your temperature? a lot of times, the cooling for an oc'd system is barely enough to keep it stable, then after a few months it just isn't. you might want to try re-applying your grease. if it works at defualt but not at the oc'd setting, a reinstall of windows is probably in order.

 

[Mem]

Run it at default speed add some case fans if you still get the same problem do what hann88 said reinstall of OS,if you still get problems I would start looking at the ram.BTW if you are using a Enlight 300w psu one of them(EN 8254942 Model AX2-5300F(B) is only recommended up to 800mhz,so overclocking might be putting too much load on PSU if you have that model.

 

[stockjock]

I have taken the CPU back to its default speed already and I don't think it is the cooling, my system is probably overcooled. I have the Alpha P7125 mounted to the heatplate with the plastic casing removed. I also have two exhaust fans on the rear of the case along with a slot cooler for the vid card and then I have 2 intake fans in the front of the case as well as HD cooling fan in one of the 5 1/4 bays. I was afraid of those answers...reinstall OS....I'm probably gonna have to do that....just thought someone might know what the OE error codes were....

 

[Mem]

If you have the HPS-300-101 Rev C Enlight PSU then this is fine(recommeded up to 1.1Ghz),you should be able to reinstall the OS over the top of itself(like a upgrade)this what I did & it worked fine,it kept all my software execept(DirectX7A) so I just had to reinstall DirectX7A.

 

[stockjock]

ok..I'm gonna try a re-install over the top....