KT7 RAID won't detect my IBM 46.1GB 75GX UATA100! Oh the humanity!

[Nefir]

I've tried connecting the hard drive to IDE1, IDE2, IDE3, and IDE4, (the last two being the RAID on which it was meant to run) but it is not detected! Autodetection won't find it, and the [Ctrl]+[H] to enter RAID bios doesn't seem to work at all! I've been using the cables that came with the KT7-RAID, since the hard drive was sold as bulk, thus had no cables, manual, or box. The hard drive does warm up a bit, but I am not sure if it spins up. The hard drive activity lights on my case don't seem to work... I think I wired them wrong, but thats another story. HELP!!!

 

[Techwhore]

Have you tried manually entering the HDD?

 

[BigDave]

Make sure the power connector is plugged into the drive properly. When the computer boots up, put your hand on the drive so you can feel if it's spinning up or not.

Make sure the jumper is set up properly as Master.

Try using a different IDE cable. And make sure it's an ATA66 cable.

That's all I can think of...