Know any good sites that show how to put blow holes in your case?

[Spoooon]

I was surfing around and I remember seeing it. But for the life of me, I can't find the damn site again. Even went to every page in my history folder. ARGH.

 

[Diceman]

http://www.tweak3d.net/articles/casecutting/

also http://www.2cooltek.com and click case mods 101-102 on the right side....

and finally..... http://www.pyramid19.com/vh/projects/index.htm

the last is very good....... my case is almost exactly like the Q600n mod...

i have a few blowholes and it is an art to make exterior blowholes look factory!.........

 

[Mday]

THE ORIGINAL

http://www.hardocp.com/articles/cooling/blowhole/ocp_blowhole.htm

 

[helloedchen]

Defintely check out VH's case gallery, hes got a ton of info on it. I've got some info on my site too if a full case is what ya got

 

[Ulysses]

Search the AT forums for another thread on this subject. I know I saw something recently on how to actually cut the round hole itself. The best suggestion was a device that was not too expensive and would cut a hole of varying diameter starting from a pilot hole.