K8N Neo2 Raid Question!

[bkspitfire]

Hey everyone. I'm reinstalling XP here, and I was wondeirng if it was possible to switch my raid 0 setup (2 disks on sata 1&2) to the 3/4 sata slots so that i can overclock my cpu again. Any suggestions? I had to install XP while the two disks were on the 1&2 sata slots because it doesn't work while they are both on 3/4.

I think i read somewhere last night through google that it was possible to switch raid arrays between these sata slots?

Thanks in advance!

 

[blckgrffn]

Make sure that you have the drivers installed for the external controller first, and cross your fingers and hope that windows doesn't crash and burn... remember to reconfigure the bios to reflect the new stripe...

Good luck

 

[bkspitfire]

thanks for responding blckgrffn. I just tried after installing the nvidia 6.39 beta drivers, set new array, and when XP goes to start i see it start to show the "windows xp" first logo, and then I get the blue screen of death. DOH! when i put it back to the original array and on sata 1/2 it woks fine again. Any other suggestions? i really would like to get this working. Thanks!

 

[blckgrffn]

You are doing well to get that far... make sure that you are striping them the same, with the same drives being 1&2 being 3&4, and try combinations of that... XP tends to hate moving to new sata controllers...

Not sure what else to try! I hope that someone else has a a better answer...