Iwill KK266 v1.1 same problem

[nairii]

I got the board a month ago from Newegg.

I put the mobo in the case and intall everything
put the settings on 100x10 (Duron 600)
boots at 1000Mhz no problem
switch the jummper to 133x7.5 no problem
140x7.5 no problem. This is all my memory can do

Then I hear about the new bios that takes the volrage down all the way to 1.2volts.
I update the bios, 10x100 posts at 986Mhz
a week later I update the bios with the newer bios and I can never again change the multiplier, I have the L7's conductive penned,

specs:
KK266 V1.1
Duron 600
generic 256MB ram
TNT2
Realtek NIC


I e-mailed Iwill days ago and I have yet to get a response from them


Do all you V1.1 owners experience this thing?

oh yeah the 0ohm resistors are at the right place (R356)


Thanks in Advance

 

[nairii]

bump

 

[sweetboy]

bump

 

[nino]

I personally run the original bios on my computer. It seems the most stable for me and I have the ver 1.1 but I haven't really done a lot of testing to validate my claims. Just reflash to your original bios. If you don't have it then send me an email and I'll send it to you.
nino@purdue.edu

 

[nairii]

nino u got mail. and Thank you