IWill KK266 - Clear CMOS?

[gizbug]

What is the procedure with clearing the CMOS on this board?

Put the jumper to the appropriate setting, wait a few sec's and put it back?



I ask in reguards to a post I posted in a different forum, with regards to my computer not booting up at all.


Thanks

My Problem Post is Here

 

[FrontlineWarrior]

yup, just put the jumpers in the other configuration for a second, remove, and put the jumpers back in the original config.

 

[j24u]

unplug your PC 1st - then push the power switch - sometimes the capacitors retain a bit of voltage - you can see the fans spin for about half a second - now you are good to go