It's over!!!! Board headed to RMA land :(

[mastertech01]

Resets the processor setting to default to enable a boot when you have gone past the cpus ability to post in the cpu settings.

 

[BAMAVOO]

But in my case it doesn't matter on the Insert Key..All lights are lit and keyboard has no effect.Num lock caps lock and scroll lock that is..


Anyone have any answers or is the board just dead?

 

[M O M O]

Friend of mine had similar problem.. We tried everything.. New power supply, mb,videocard, and so on. Ended up being his stick of ram. It was toasted. Just something to try if you havent already .. Hope you get it working

 

[BAMAVOO]

Got two sticks that I have tried in it...Stick of Mosel and a Stick of generic..I also have a stick of Infineon I have not tested..Don't think that is it though..Thanks...Any more ideas..Personally I think the board is DOA..

 

[rarebear]

I read about the Artic Silver all over
my 650 I put little dabs on the corners of the shim and a dab on the core will my dab being a newbie is enough for 10 CPUs, I had it all over the place and it don't come off with alcohol it just smears all over..
But my CPU is working fine..

Also to remove Loctite a razor and alochol work great for big blobs ..

 

[lane42]

BAMAVOO, Sorry to hear the power supply didnt help.
Good luck and i hope you get that sucker going.

 

[myztikal47]

Remove everything except the CPU, vid card and ram, take those 3 thing out, and put them back in and see if they are seated correctly. Then reset the BIOS too, then see if it boots.

 

[BAMAVOO]

Man I have done it every way I can think of..It is a no go! I have had the video mem and a stick of ram only..Th cpu only..I don't even get beeps!!!!

 

[lane42]

Did you have a user's manual for the pro2.
In mine, under Diagnostic LED Function it say's,
" four red LED's will hang-- The processor might be damage or not installed properly".

 

[BAMAVOO]

Yep..But I don't have that board now..In this board I dropped a 700 duron and it does the same old same old....NOTHING