Platinum123
Junior Member
Plugged the my monitor into my second comp to upload some seti blocks and the picture only filled half the screen, strange i thought, as the machine is not in a case i thought i must have dislodged the vid card from the agp slot as its not held in place by thhe case so i rebooted the machine, everything looked good untill it loaded windows where i was greeted with a very garbled screen moving in and out and making a high pitched noise, the sort of efect you get when you run a monitor at a res its not designed for, after some messing about i found it to work at lower resolutions / refresh rates, the best i am able to run now is 1152 x 864 x 16 bit, i was using 1280 x 1024 x 100hz, i was also using the refresh rate fix proggy as on xp it only lets me set to 75 max as standard, when this proggy is run it says i can run 120 hz where as the max rate for that res is 100, i set every res to max and checked in the propertys and that displayed 100, the only thing i can think of is that it was running at 120hz? the osd said the vertical refresh was 100 and horizontal was a little higher.
the monitor is a iiyama vision master pro 451 which from all reports are very unrealiable 🙁
anyhow my thoughts are RMA time 🙁 and what with christmas next week i might not get it replaced till the new year ;(
the monitor is a iiyama vision master pro 451 which from all reports are very unrealiable 🙁
anyhow my thoughts are RMA time 🙁 and what with christmas next week i might not get it replaced till the new year ;(
