Soulkeeper
Diamond Member
my bios offers vcore range 1.2125 - 1.8325v
I'd sure like to see something more like .90 - 1.35 instead
setting the vcore to 1.2125 results in actual 1.18v (1.14v when speed stepped down to the lowest)
I want lower
anyone have experience with such an issue ?
I just tried the "pin mod" on cpu, but it was ignored
I've studied the datasheet on the pwm for this board and know exactely what i'd have to do in order to hard lock a particular voltage ...
It's just the pins as so small I can't even get my multimeter point in there to do a continuity check
the pins are .5mm apart center to center ie: 40 pins smashed in an area less than half the size of a penny
besides I shouldn't have to go thru such extremes
any ideas ?
I'd sure like to see something more like .90 - 1.35 instead
setting the vcore to 1.2125 results in actual 1.18v (1.14v when speed stepped down to the lowest)
I want lower
anyone have experience with such an issue ?
I just tried the "pin mod" on cpu, but it was ignored
I've studied the datasheet on the pwm for this board and know exactely what i'd have to do in order to hard lock a particular voltage ...
It's just the pins as so small I can't even get my multimeter point in there to do a continuity check
the pins are .5mm apart center to center ie: 40 pins smashed in an area less than half the size of a penny
besides I shouldn't have to go thru such extremes
any ideas ?
Last edited:
