• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

In search of my memory dividers...

T

thawolfman

Lifer
Heya guys, I've got an A7M266 w/ 1600+ @ 10.5x155(1627) There a few things that suck about this board, namely the multiplier is locked(unless anyone wants to attempt this: mod), and you also can't adjust the voltages through the bios(jumpers suck). I can't seem to find where to change the dividers for my memory, but I found a few options where you change the CAS timings and such, and was wondering if they made much sense to anyone. They are:

Software DDR PDL Delay - If set to manual it gives some High Nibble & Low Nibble which you can adjust from 0-9, A-E

DDR Slew Rate - Options are Auto or 1-7
DDR Command Driving - Options are Auto or 1-3
DDR DQS Driving - Options are Auto or 1-3
DDR MAA & MAB Driving - Options are Auto or 1-3

I appreciate any help 🙂
 
I'm currently running the same board and I don't think you have any other choice in memory dividers than 1:1. The options you mentioned are pretty arcane and I've basically left them all on auto. I turned off the SPD timings and set them to 2-2-2.

In short, if you want to run the memory faster than 133Mhz, you're going to raise the FSB.
 
You must log in or register to reply here.

TRENDING THREADS

Back
Top