I'm too used to PIII's so what am I doing wrong? CUSL2 / C633.

[compuwiz1]

This board must need something different to run a C2 in it. I must have overlooked a setting, dip switch or jumper, but don't know which. Anywone been there? 😉
Tried 3 different cpus, no post.

 

[Wolfman35]

Steve, Are you sure you have the dips set to "Jumper Free" ??? I have a CII 600 at 900 in my CUSL2 working fine. I bet you got the dips set for 133 (or 100) FSB.

 

[compuwiz1]

They're all off, which is supposed to be jumper free. Can't get any of them to post in it. All my PIII work fine. ????

 

[Mday]

you're not trying to overclock it straight off are you?

 

[compuwiz1]

No....no overclocking. Won't post at default. Will try the on one of the other systems later.

 

[BradS]

I wish I could offer something to help. I had a CUSL2 with a 633@950 running for about 4 weeks. No problems and rock solid. It has the 1001a bios. But I doubt a newer bios would be causing your problem. When I swapped the C2 for a P3 I did nothing to any board settings.

 

[Oyeve]

I had a similar issue with an abit bf6 board once. I first put in a celery 333 and all was ok then I put in a 650 and it wouldnt post. I put back the 333 and it still wouldnt post. Turns out it was a well know bios bug and I had to send the board back. Maybe this is what is happening to you.

 

[Aboroth]

My CUSL2 wouldn't run my Celeron 633 either. I didn't really care because that wasn't the board I was going to use it with, but it was still aggrivating. There have been quite a few BIOS updates since then though, so it might work now.