I am trying to boot a computer I recently built (DFI RD600 Gaming rig Stage 1 in my rigs)
and it auto powers down around 10-15 seconds after start up. Everything before that is fine. When I press DEL to enter setup, I get a Promise FastTrack TX4310 BIOS (etc.)
screen that says "Searching for drives..." and then "No array found. " I would go into the BIOS if I could (if this screen wasn't there and if it didn't power down almost immediately). Also on the POST screen it says CMOS Checksum error - defaults loaded. I cleared the CMOS by EZ reset buttons and the jumper -- hasn't gone away. I doubt the CMOS is causing this behaviour though. Please help! Any ideas before RMA?
Specs:
*troubleshooting ATM*
DFI ICFX3200-T2R/G
Intel Core 2 Duo E6600 stock w/ stock Intel cooler
2 x 512MB Infineon PC2-3200 3-3-3-8 (tried both sticks individually, no change in board behaviour -- worked in another PC.
ATI X1900 XTX @ stock
Western Digital RE 250GB SATAII x 2
Plextor PX-755SA SATA DVD+/-R/W x 2
Enermax Liberty 500W
ASUS Vento 3600 (Black
and it auto powers down around 10-15 seconds after start up. Everything before that is fine. When I press DEL to enter setup, I get a Promise FastTrack TX4310 BIOS (etc.)
screen that says "Searching for drives..." and then "No array found. " I would go into the BIOS if I could (if this screen wasn't there and if it didn't power down almost immediately). Also on the POST screen it says CMOS Checksum error - defaults loaded. I cleared the CMOS by EZ reset buttons and the jumper -- hasn't gone away. I doubt the CMOS is causing this behaviour though. Please help! Any ideas before RMA?
Specs:
*troubleshooting ATM*
DFI ICFX3200-T2R/G
Intel Core 2 Duo E6600 stock w/ stock Intel cooler
2 x 512MB Infineon PC2-3200 3-3-3-8 (tried both sticks individually, no change in board behaviour -- worked in another PC.
ATI X1900 XTX @ stock
Western Digital RE 250GB SATAII x 2
Plextor PX-755SA SATA DVD+/-R/W x 2
Enermax Liberty 500W
ASUS Vento 3600 (Black
Facebook
Twitter