I Need Help

[Amused]

Yeah Yeah Yeah... in more ways than one, right?

Anywho, this is what I need help with:

I'm replacing a friends old hard drive with an Iwill RAID card with two HDDs in RAID-0 on his Dell. And he wants me to clone the old drive to the new rather than reload Windows and everything else.

I've been advised to use Ghost to clone the disk, and am picking up a copy of it tomorrow

OK, here's my question, how do I go about this? Do I remove the old drive and hook up the RAID card and two drives FIRST, then configure the RAID, and then hook back up the old drive and run Ghost???

If not, can someone give me a detailed step by step on how to do this?

I've built a couple of RAID setups before, but I always just loaded Windows on it, never tried to clone a disk to it.

Thanks

 

[Amused]

Bump, 'cause I'm pathetic and have an excuse.

 

[GL]

Bump. If you post this in General Hardware you'd probably get a quicker response though.