i have a couple of questions about my new Antec P160fw case

[ty1er]

hello everyone.

over this past weekend i finished up putting together my new amd64 system into my Antec P160FW case.

Ok, here i my questions reguarding this case.

1. On the front LED temp display of the case im guessing that it suppose to cycles through two temp readings, but on the second temp reading it displays an "-H" instead of a temp reading. What gives?

(EDIT: Problem Solved]2. Also the Acrilic Side window of the case came with a layer of plastic rap to protect it. But when i removed the plastic it left behind glue residue. What should i use to Savely remove the glue without scratching the acrilic window?(EDIT: Problem Solved]


thanks
-ty1er

 

[CraigRT]

I'd just use warm soapy water and a soft cloth to remove the glue residue.. as for the temp readout, I have no clue

 

[fisheye]

That temp readout sounds screwy... never saw that on mine (I have the same case)

 

[ty1er]

Originally posted by: fisheye
That temp readout sounds screwy... never saw that on mine (I have the same case)

when i get home im going to double check the wiring, could be a bad connection....
if not, im going to email Antec, im thinking that its probably a bad temp senser.

 

[ty1er]

2. Also the Acrilic Side window of the case came with a layer of plastic rap to protect it. But when i removed the plastic it left behind glue residue. What should i use to Savely remove the glue without scratching the acrilic window?

Just incase any one would like to know...

Well i went ahead and used regular rubbing alcohol (50% by vol) and cotton balls to clean the acrlyic.
Then did a final wipe down with alcohol on a old cotton t-shirt to get rid of any "cotton fuzzes" that the balls left.
THat did the job, super clean and it did't scratch the surface.