I can't unlock the multiplier by connecting L1 bridges...

[hanc0]

I've tried it about six times, and I am getting tired of it. .llll <- I did this, and my motherboard (KT7-RAID) won't run 850(default mhz)+ If I set the mult. at 9, for example, it will post 8.0x100<800> and 850, 750 at anything higher than 8.5 So what am I doing wrong? I've tried it a lot of times, and I am pretty sure the bridges are correctly connected.

Any idea?

Thanks for help.

 

[office boy]

What are you connecting with? (exactaly what)

 

[hanc0]

Well, I've tried two kinds. 0.3mm mechanical pencil with HB lead, 0.5mm mechanical pencil with HB.

 

[office boy]

I don't know. It worked fine for me, one the first try too...
I used a regular #2 pencil

 

[Elbryn]

if you are getting wierd results most likely its that the penciling job was done right. I had much the same problem with my duron 600. First 2 times i tried i would get some really wack numbers when trying to change the multipliers. I would try penciling again or getting the locite rear defroster gunk and give that a go.

 

[hanc0]

wow it worked ths time. i guess i did too much before. running at 1000mhz(10x100) @ 1.825v