How To Set up wireless ethernet bridge

[cndesu]

Hi,

I have two wireless routers one of which contains dsl modem(zoomadsl) too. Now I donot want too many routers/switches to extend my setup. I have a network in one room. This has wireless router called main. In another room I have bedroom computer and printer to do my small work. Now I want to bridge these routers. How? The following is my setup...

DSL modem.....>>TrendNet Wireless Router.....>>Laptops two of them
Zoom ADSL x6V Wireless Router......>> Bedroom Computer and MFC Network Printer

I want all these on same subnet. Is it possible?

Thanks

 

[JackMDS]

If the TrendNet can be configured as a Wireless Client Bridge it can be done.

Otherwise, you have to get another Router that can.

Very few Routers can do this As Is. Many Wireless Routers can be flashed by DD-WRT free 3rd party firmware, and then configured as bridge.

Here is a list of Routers (end of page), http://www.dd-wrt.com/wiki/index.php/Installation

Here how to configure, http://www.dd-wrt.com/wiki/index.php/Client_Bridged

 

[cndesu]

Thanks for the reply.

But I have some clarifications before I go on that step. Now If I do the Trendnet ROuter as secondary router (in Client mode) then the Zoomadsl router would be main router. Can I disable the dsl modem and Voip features and can I use only the router part? If so how? I saw only PPPoE, 1483 Bridge mode, 1483 Bridge + NAT, 1483 routed IP mode. Now which one I have to use to get the dsl modem and VoIP out of the router and only router section. I have already have dsl modem which is more reliable than this one! If possible can you please let me know then everything would be fine!

Thanks once again.