How to remove the top off of the Antec SX-1030

[xXgambitXx]

I want to drill a hole into the top of my SX-1030 clone. LOOKS LIKE THIS. i can't figure out how to get the top panel off of this thing. i have no idea how to do this, any help would be appreciated, thanks.

 

[NesuD]

far as i can tell they aren't made to be removeable. They are riveted in place. I suppose of you drilled out the rivets you might get it off. why do you have to remove it to drill a hole in it? Just take everyting out of the case and then drill it. Be sure to clean up all the metal shavings real good be fore you put all your hardware back in it or it could be POOF! city.

 

[FlowerMan]

drilling out the rivets would be much cleaner. No need to get the entire case frame dirty when you can just drill some rivets out. You can either replace them with rivets again or find some small screws that will fit.