how to make dual channel in NEo 4 Platinum

[Serch]

to make dual channel I have to put one module into one channel (lets say DIMM1 - green channel) and the other module in the other channel (DIMM2 - purple channel) I have 2 modules of 1 Gb each, is it correct?

the manual is confusing, becouse it shows two charts and two notes saying that putting double sided modules in 1 and 3 (both green slots / the green channel) the frecuency goes down to 333mhz (instead of 400), and the other situation tells that when all the dimm slots are full with double sided modules, it goes to 333 Mhz too. I don't like that very much I must say.

Look in order, they are little dark coz I didn't use the flash :
1 http://tinypic.com/keaeko.jpg (little out of focus.. can be readen though)
2 http://tinypic.com/keah4j.jpg
3 http://tinypic.com/keahdj.jpg

 

[theShark]

correct, one in the green and one in the purple.

 

[Wentelteefje]

If you put them in the rigt way, it'll say upon POSTing, it's one of the upper lines of the screen... Something like "2048MB DDR400 128-bit Dual Channel" I thought...

 

[natep]

I did green/green at first, but then saw that it booted up in single channel.
Need to do green/purple, they'll be right next to each other.