A year ago my Intellieye Explorer died, the classic bad wires where they come into the mouse story. :disgust:
Well 1 week ago I remove the rubber feet on the bottom, removed the screws.. cut off 2 inches of wire from the point where the wire comes in the mouse... well i took 1 inch of either side.
Then I rejoined the wire together trying to make sure that not a whole lot of wire is uncovered by the protective mesh of wire that spans the wire.
Put everything back together and it all works!
The leds are fine, all the buttons are fine, everything is fine.
Happy Me? Not so, cause after a few days I notice that when I move the mouse just a little too fast..the crusor just jerks around..going back an inch or so. Otherwise everything is fine.
I've got win me.. this problem happens all the time, regardless of application. I've also got the latest drivers (3.2)
/me flass down on the floor and begs and crys for help.
Well 1 week ago I remove the rubber feet on the bottom, removed the screws.. cut off 2 inches of wire from the point where the wire comes in the mouse... well i took 1 inch of either side.
Then I rejoined the wire together trying to make sure that not a whole lot of wire is uncovered by the protective mesh of wire that spans the wire.
Put everything back together and it all works!
The leds are fine, all the buttons are fine, everything is fine.
Happy Me? Not so, cause after a few days I notice that when I move the mouse just a little too fast..the crusor just jerks around..going back an inch or so. Otherwise everything is fine.
I've got win me.. this problem happens all the time, regardless of application. I've also got the latest drivers (3.2)
/me flass down on the floor and begs and crys for help.
Facebook
Twitter