How do I go about updating/uninstalling VIA drivers?

[Imaginer]

Everytime I seem to hit install, nothing changes. Do I uninstall old VIA drivers first? How do I go about uninstalling them if I do?

 

[Heretik]

I had to "manually" update the VIA IDE drivers to get them to install correctly. I could have missed something along the way, but this seemed easiest to me. Just go into device manager/hard disk controllers and click (one at a time) properties for VIA Bus Master PCI IDE Controller, Primary Bus Master IDE Controller, Secondary Bus Master IDE Controller....click driver tab, then update driver and point it to folder where your VIA drivers are. I was having problems with my internal ZIP on my Pro-2A even after installing newest VIA drivers. Upon looking closer, I realized it hadn't really updated the drivers at all......

 

[nilanjan]

I just want to add that if you are installing the 4in 1 firt install the inf driver before anything else.

 

[potz]

to uninstall, run the setup utility again and tell it u want to uninstall the drivers. to update, do the same and tell it you want to INSTALL the drivers =)

but i'd recommending first uninstalling then installing the updated ones

 

[Hardnut2K]

Boot up in safe mode and then uninstall the drivers, you should see any left over drivers, or extra ones left over from card swapping.