Jayczar
Golden Member
I am no stranger to striping with RAID but I cannot seem to get the controller
to recognize both my drives. I have 2 identical WD ATA-100 drives and have
tried every possible cable and jumper configuration and can only get one
to show up. The manual says to master both drives and put them on different
channels but it doesnt seem to work at all. I have verified that both drives
are good and the cables are good as well. Any ideas let me know.THX.:|
to recognize both my drives. I have 2 identical WD ATA-100 drives and have
tried every possible cable and jumper configuration and can only get one
to show up. The manual says to master both drives and put them on different
channels but it doesnt seem to work at all. I have verified that both drives
are good and the cables are good as well. Any ideas let me know.THX.:|
