help motherboard install on enlight 7237...

[stanger]

I have an enlight 7237 ATX case and gonna install the ASUS CUSL2-C motherboard on it.... ok the case already has 6 small metal stands that the motherboard i guess sits on and there are a few more in the bag of bolts from enlight. I dont see any washers of any type does the motherboard sit right on top of the metal stands without any insulators between the board and MB tray? i was worried because i have read here about some type of red washers that comes with the cases, i just dont want to fry a new motherboard so i wanted to check with you tech guys first

stanger

 

[jstdenis]

Just installed Iwill K266 in that case. No washers needed here; just added a few standups(included in the bag of bolts)to mate with mounting holes on MB. I think the worst that can happen is short to MB and no boot; no nothing. If you experince prob boot up outside case. If it boots outside the case but not mounted in the case then you have a short to MB prob.

 

[GAZZA]

Just make sure that the holes line up correctly to the screw posts and you'll be fine , those holes are isolated so you wont have any issues but if it makes you feel any better you can always use some thin card or even plastic in .between

 

[stanger]

thanks

 

[max105]

i've got almost the exact setup as you except I have an CUSL2 motherboard. I think theres only a total of 6 screw mounts for the motherboard and the case to connect. I don't have any washers between the case and the motherboard and it's runninng fine. Never had any problems, so i don't think u should either.