Help! Just overclocked my t bird 800 - won't boot

[timebecomes]

Here is the situation. I was trying to overclock my t bird 800, and I have already connected the l1 brides by pencil. I tried it at 816 to start, and it worked fine. Then at 856, also worked fine. At 912 it will boot up to the very first few lines of DOS text that say hit delete to enter setup, and my keyboard stops working. I have checked connections and everything, and I have unplugged everything out of the back besides the keyboard and power supply. I have also tried someone else's keyboard. Any suggestions as to how I can get it back to a normal setting? Any help would be greatly appreciated. - Thanks -

 

[iwishiwaselite]

Reset your CMOS.

Consult your manual for information on howto.

 

[WarCon]

Its almost always hold the insert key down, while you turn the power on to put your processor back to default. If not you can always clear the cmos with the jumper and that will do it. Only pain there is default everything.

Good Luck