HDD to mobo to xp pro install problems???

Triple B

Junior Member
Mar 26, 2005
23
0
0
dont know where to start but system specs are in sig and my HDD is an oldschool Fujitsu MPD3084AT. 8.4g 5400 ata/33. seriesly slow, i know. but on a budget for next few months....paying back school loans is a $@#%$#.
with that said. i can post and get into bios and set everything up fine. but once i go to install xp pro, legit copy it STALLS on the last part "Finalizing insallation" "setup will complete in aprox 9 mins" and it is -saving the settings-. it has been here for 1hr 29 mins now. this is the second time i have done a full reformat. and if i cancel and restart install i get blue screens of death saying there is an device error.
my mobo manual says it will support my UDMA ata/33 hdd.

is there something im missing with my system being all new and 64bit but my OS and HDD not being that? i dont know if there are any settings i need to change...it all should be automatic.

i guess waiting longer for the OS install to finish wont hurt anything. maybe since my HDD is so slow 33mb/s it will jsut take forever.

does anybody have some words of or helpful hints. i know i should get a new HDD, i will by july for sure. but for now i need to have my comp working.

thanks
 

Basie

Senior member
Feb 11, 2001
634
0
71
Do you have the hard drive installed by itself on the Primary IDE channel as Master? Also, if you
can remove one ram module try that. Disable Antivirus detection in the Bios and set to
Optimal or Default settings. Check to see that the Primary IDE Channel is set to Auto.