Gigabit GA-H97M-D3H -- can it do dual monitor with IGP

[Homerboy]

I'm fairly clueless when it comes to IGP.

If I'm using a GA-H97M-D3H with an i5 4460, can I run dual monitors (HDMI and DVI) with it? I assume so, but just want to make sure.

 

[LTC8K6]

Probably VGA and one of the other two?

 

[LTC8K6]

Triple-Display Configurations for the Onboard Graphics:
Triple-display configurations are supported after you install motherboard drivers in OS. Only dual-display configurations are supported during the BIOS Setup or POST process.

That's from the board manual, but it's not clear if that means both Z97 and H97 chipsets.

 

[Homerboy]

Probably VGA and one of the other two?

I dunno, that's why I'm asking
Why couldn't it be HDMI and DVI?

 

[Homerboy]

Well it does dual, but I can't have them both plugged in at same time? Gets stuck at bios splash screen.

 

[LTC8K6]

Check for BIOS settings that would enable multiple display mode.

 

[Homerboy]

Check for BIOS settings that would enable multiple display mode.

I did and didn't find anything. Sadly, I was setting this up at a friends studio and really didn't have access to the internet besides my phone at the time.

It's odd - If I boot it with HDMI and VGA plugged in, both screens get the bios splash screen "America Megatrend" or whatever and nothing else (no CPU/memory detection) and just hangs there.

If I boot with just the VGA in, and let it get to Windows login, THEN I can plug in the HDMI and everything falls into place.