Giga-byte GA-7AX/AXP

[KonaMonkey02]

Can someone please tell me how to change the CLK_RATIO ( mulipliter) other than using the onboard switches? I ask because I want to overclock my CPU, and I want to raise the muliplier rate. I am trying to get to a 16X muliplier, and all I can get it 12.5 through the use of the on-board switches. THANKS!

 

[KonaMonkey02]

anyone?

 

[KonaMonkey02]

please......

 

[KonaMonkey02]

PLEASE!!! DOES ANYONE KNOW HOW TO ADJUST THE MULIPLIER RATE ABOVE 12.5 (which is the maximum allowed through the use of the on-board dip sticks)

 

[billyjak]

What are you trying to do. Get a higher oc or what?
You can get higher by setting the SW1 to 133mz or 166mz
Use the diagram below and change the dip switch accordingly to get a faster clock
Your mobo only goes to 12.5 multiplyer, you can't raise that higher but you can change the mz as seen below to get a higher speed.
On your mobo the dip switch changes are below
It's labeled sw1 on your mobo. you cannot change the multiplyer higher than 12.5 just the memory speed , this will give you a higher mz reading.
You may have to push the multiplyer dip switches down if you go to high.


SW1
100mz 133mz 166mz
1 on off off
2 off off on