Ghost Troubles

[hackmole]

I can't get Ghost to work. Ghost recognizes my partitions but after it is through making an image of the files in my primary partition and putting it on another partition, it doesn't finish even though it says 100 percent complete. It continues to add more megabytes copied and starts showing negative numbers for the time. I then have to restart the computer to stop it and when I look at the Ghost file that was copied to the I drive with the properties option, it says it contains zero bytes.

I also tried to use the -FNI switch in the Ghost Options that someone recommended but that didn't help either.

I'm using an overlay program called EZbios and don't know if that might be a problem or not but I can't go without EZbios or I can't get full use of the drive if any use.

 

[hackmole]

OK, I tried it again and waited another 10 minutes past the 100 percent mark until it copied my entire primary partition and said that the Dump was finished. But when I restarted back to Windows and went back to look at the file in Ghost Explorer, it said that the file was corrupt.

 

[Argo]

Run scandisk or norton disk doctor.