GF3 Ti-200 Stability Question

[pookguy88]

Ok, I got my Visiontek GF3 Ti-200 running at 220/500 for 3 hours on 3DMark2001 and 0 artifacts both on 3DMark2001 and on Artifact Tester 5, but sometimes it bonks out in Q3...

 

[zephyrprime]

Are you running the Q3 demo? Seems to me that if it bonks out in anything but it doesn't when not overclocked, it's being pushed too far.

 

[pookguy88]

well the Q3 timedemo loop will run fine, its just when I play RA3 it'll bonk out...

 

[EXman]

You must have a week 44 visiontek ti200 my week 42 will not go 500. I hear the memory could go alot higher if you work this problem out. (say almost 550mhz)

 

[SilverBack]

pookguy88
Just clock the card to it's defaults and see if it locks up again. If not just slowly raise the timings until you "bonks out" again.